PT Pro Slide-On Adapter Ring for Segway PT InfoKey
This PT Pro slide-on adapter ring screws onto the rear thread of the Segway PT InfoKey. Its integrated guide allows the InfoKey to slide into a compatible holder.
This provides a simple mechanical interface for mounting the InfoKey to the vehicle or another suitable holder.
Suitable for Segway PT i2 and x2
The adapter ring is suitable for the corresponding InfoKeys used with:
- Segway PT i2 Gen2
- Segway PT x2 Gen2
- Segway PT i2 SE
- Segway PT x2 SE
It can therefore also be used with compatible Segway PT-based seating systems and balance wheelchairs where the corresponding Segway PT InfoKey is used.
Slide the InfoKey into the Holder
The adapter ring is first screwed onto the rear of the InfoKey. The InfoKey can then be slid into a compatible slide-on holder using the integrated guide.
This solution is useful when the InfoKey should have a defined position on the Segway PT or vehicle while remaining easy to remove when required.
PT Pro practical tip: After inserting the InfoKey, check that it is fully and securely seated in the holder. The adapter ring and holder must be compatible with each other.
Can Also Be Used with a Wristband
The slide-on guide can alternatively be used as an opening for a suitable wristband. This allows the InfoKey to be worn on the wrist without requiring a separate wristband adapter.
The preferred solution depends on whether the InfoKey is mainly mounted to the vehicle or carried directly by the user.
Simple Installation
The adapter ring screws directly onto the existing thread on the rear of the InfoKey. Tools are normally not required.
Start the thread carefully and avoid unnecessary force to prevent damage to the thread or InfoKey housing.
Scope of Delivery
- 1 PT Pro slide-on adapter ring for Segway PT InfoKey
Note: InfoKey, slide-on holder and wristband are not included unless expressly offered separately.
Product safety information
Manufacturer information:
PT Pro GmbH & Co. KG
Feldbauerstr. 5a
Bayern
Amberg, Deutschland, 92224
info@ptpro.de
https://www.ptpro.de
Important warning! Risk of injury!
General:
- When using our products, it is important to follow the instructions for installation and manual and the warnings associated with them.
- Special care must be taken while handling with electricity.
- When driving on the road, always observe the locally valid laws and regulations!
- Ensure that you wear adequate protective clothing
- If the vehicle is damaged, it may not be driven under any circumstances. Danger of injury!
Mounting:
- Always switch off your electric vehicle and disconnect the power cable before carrying out maintenance work or replacing parts or accessories.
- Remove both batteries / accumulators before starting work.
- PT Pro is generally not liable for damage caused by incorrectly installed attachments, wear and spare parts.
- Always read the latest authorized operating and installation instructions before installation
- In order to avoid damage and malfunctions, installation should only be carried out by qualified personnel! Incorrect mounting can lead to death or serious injury.
- To minimize the risk of injury, please read and follow all instructions and warnings in the user documentation
Driving the vehicle:
- Use of the vehicle can become deadly or result in serious injury due to loss of control, collisions and falls.
- To minimize the risk of injury, read and follow all instructions and warnings in the user documentation.
- PT Pro recommends that you always wear a helmet when driving the vehicle.
- When using the vehicle, the current road traffic regulations in the respective country must be observed
- Always store batteries and accumulators in a dry place and at room temperature (10 - 25 degrees)
- Charge batteries only at adequately fused sockets and with charging cables designed for this purpose
- Protect batteries and their connectors from moisture
- Always switch off your electric vehicle and disconnect the power cable before carrying out maintenance work or replacing parts or accessories.
- Remove both batteries / accumulators before starting work
- Do not clean with steam jet or garden hose or drive through deep puddles! Clean with a damp cloth!
Lamps:
- Please always ensure sufficient battery power for the duration of your ride.
- Never look directly into the light source. This can lead to blindness
Rims:
- Important: Risk of crashing:
- Check rims for damage before every ride!
- Rims with out-of-balance or which show knocks, hairline cracks and deformation must be replaced immediately.
- Hairline cracks are difficult to detect, danger of breaking! Hairline cracks are possible, especially after accidents and after riding fast over high edges (high pavement, thick roots etc.). Here you save at the wrong place!
- Regularly check the screw connection of the rims!
- Never use rims as load securing points (lashing strap!). Lateral tension forces can damage the rim.
Helmets:
- Caution: Not suitable for motorcycling!
- Please read the warnings inside the helmet!
- Only wear the helmet while riding. Danger of strangulation due to getting caught on the chinstrap when climbing or playing.
- The helmet can no longer fulfil its protective function after a fall, so replace it after every fall.
- Materials age due to UV radiation and external influences. To ensure optimum protection, safety helmets should always be replaced after approx. 5 years.
Caution:
Electronic components are generally excluded from return, cancellation and conversion, as these are specific individual productions due to the respective programming of the component or customer-specific optimizations. Complaints can only be accepted if the component was installed by a trained PT Pro technician. In case of self-installation, any form of warranty or guarantee expires. We refer here to § 312g paragraph 2 BGB additionally apply: I. Exclusion already before the beginning of the production of the goods II. Exclusion only in case of considerable economic disadvantages for the entrepreneur.
