Elastomer PT Pro Org medium for gearbox Segway PT

Elastomer PT Pro Org medium for gearbox Segway PT

SKU: 80417
GTIN: 4251445404236
HAN: 4251445404236
Category: Segway PT Gearboxes, Couplings & Parts
Manufacturers: PT Pro GmbH & Co. KG

The PT Pro Elastomer (gear rubber) made of special plastic, material hard for all Segway PT models. Power transmission component between engine and gearbox. Mobile up to approx. 2500km, with good gears even more! This plastic compound has been specially developed for tour providers with high season running performance and extreme tour routes ( extreme gradients ). Slightly louder in operation, but with its increased mileage less expensive to maintain.
The mileage is very dependent on the condition of the gearbox on which it is installed. PT Pro can unfortunately only guarantee this mileage with gearboxes revised by us.

€ 33,90

incl. 19% VAT , plus

Choose tax zone / country of delivery

Available immediately
Delivery time: 1 - 3 Workdays (DE - int. shipments may differ)

pcs

PT Pro Elastomer medium - For all Segway PT types

Elastomer change - important for safety, driving comfort and silent, quiet levitation

Like any vehicle, the Segway PT requires regular maintenance and service. Although the scooter is by far not as susceptible to repair and maintenance as an electric vehicle with a combustion engine, certain components such as coupling and elastomer are subject to normal wear and tear. These transmission components are very safety-relevant and must be replaced depending on the mileage and after a certain period of time. Due to the high performance of the Segway PT, the transmission parts are subject to heavy wear and tear.

The Elasto sits on the star of the engine shaft and transmits the power to the Segway PT gearbox via the coupling. Thus the elastomer together with the coupling is the most stressed wear part of the vehicle.

Elastomer change
During our cheap service work we often get to see elastomer kits that are used up to dust and shreds. This places an extremely heavy load on the gearbox and coupling!
After a short time, the coupling in the shaft mounting is also turned round. With a lot of luck it will spread for a while and keep the transmission system alive. At some point the shaft will spin under load = full speed. What this means for the safety of the driver is clear. A fall is inevitable because the Segway PT can no longer balance itself! At the latest here danger threatens the route offerer because of neglected duty of care.

To avoid risking major damage to the Segway, the Segway PT should be serviced regularly and wear parts should be replaced by an expert. Good maintenance prevents the failure of your equipment during the season!

The PT Pro Elastomer (gear rubber) made of special plastic, in the medium version for all Segway PT models. Power transmission component between engine and gearbox. Counterpart to the Coupling Mobile up to approx. 2500km. The mileage is very dependent on the condition of the transmission on which it is installed. PT Pro can unfortunately only guarantee this mileage with our revised gearboxes (Gen2).

The plastic compound used for the elastomer medium is adapted to normal driving conditions and represents a good compromise for smooth running and mileage.

Installation by qualified personnel is recommended! Incorrect installation may cause damage to the

Gearbox, Coupling and Elastomer Kit lead! For this we can unfortunately not assume any liability. Please take note of our special and favourable service offers

Quantity: 1 piece Medium

PT Pro Elastomer made of special plastic, medium for all Segway PT models. Power transmission component between engine and gearbox. Counterpart to the coupling. Mobile up to approx. 2500km depending on the condition of the transmission.

Please pay attention to our warnings!

Installation by qualified personnel only!

Product safety information

Manufacturer information:

PT Pro GmbH & Co. KG
Feldbauerstr. 5a
Bayern
Amberg, Deutschland, 92224
info@ptpro.de
https://www.ptpro.de

Condition:	New
Suitable for:	i2 Gen2 x2 Gen2 i2 SE x2 SE all Segway PT
Shipping weight:	0,01 kg
Item weight:	0,01 kg
Dimensions ( Length × Width × Height ):	10,00 × 5,50 × 2,50 cm

Important warning! Risk of injury!

General:

When using our products, it is important to follow the instructions for installation and manual and the warnings associated with them.
Special care must be taken while handling with electricity.
When driving on the road, always observe the locally valid laws and regulations!
Ensure that you wear adequate protective clothing
If the vehicle is damaged, it may not be driven under any circumstances. Danger of injury!

Mounting:

Always switch off your electric vehicle and disconnect the power cable before carrying out maintenance work or replacing parts or accessories.
Remove both batteries / accumulators before starting work.
PT Pro is generally not liable for damage caused by incorrectly installed attachments, wear and spare parts.
Always read the latest authorized operating and installation instructions before installation
In order to avoid damage and malfunctions, installation should only be carried out by qualified personnel! Incorrect mounting can lead to death or serious injury.
To minimize the risk of injury, please read and follow all instructions and warnings in the user documentation

Driving the vehicle:

Use of the vehicle can become deadly or result in serious injury due to loss of control, collisions and falls.
To minimize the risk of injury, read and follow all instructions and warnings in the user documentation.
PT Pro recommends that you always wear a helmet when driving the vehicle.
When using the vehicle, the current road traffic regulations in the respective country must be observed
Always store batteries and accumulators in a dry place and at room temperature (10 - 25 degrees)
Charge batteries only at adequately fused sockets and with charging cables designed for this purpose
Protect batteries and their connectors from moisture
Always switch off your electric vehicle and disconnect the power cable before carrying out maintenance work or replacing parts or accessories.
Remove both batteries / accumulators before starting work
Do not clean with steam jet or garden hose or drive through deep puddles! Clean with a damp cloth!

Lamps:

Please always ensure sufficient battery power for the duration of your ride.
Never look directly into the light source. This can lead to blindness

Rims:

Important: Risk of crashing:
Check rims for damage before every ride!
Rims with out-of-balance or which show knocks, hairline cracks and deformation must be replaced immediately.
Hairline cracks are difficult to detect, danger of breaking! Hairline cracks are possible, especially after accidents and after riding fast over high edges (high pavement, thick roots etc.). Here you save at the wrong place!
Regularly check the screw connection of the rims!
Never use rims as load securing points (lashing strap!). Lateral tension forces can damage the rim.

Helmets:

Caution: Not suitable for motorcycling!
Please read the warnings inside the helmet!
Only wear the helmet while riding. Danger of strangulation due to getting caught on the chinstrap when climbing or playing.
The helmet can no longer fulfil its protective function after a fall, so replace it after every fall.
Materials age due to UV radiation and external influences. To ensure optimum protection, safety helmets should always be replaced after approx. 5 years.

Caution:
Electronic components are generally excluded from return, cancellation and conversion, as these are specific individual productions due to the respective programming of the component or customer-specific optimizations. Complaints can only be accepted if the component was installed by a trained PT Pro technician. In case of self-installation, any form of warranty or guarantee expires. We refer here to § 312g paragraph 2 BGB additionally apply: I. Exclusion already before the beginning of the production of the goods II. Exclusion only in case of considerable economic disadvantages for the entrepreneur.