PT Pro number plate holder for Segway i2 cargo frame
Suitable for:
Segway i2 Segway i2/Gen2 Segway i2/SE
The extremely robust PT Pro license plate bracket for the PT Pro side bar i2, complete with plate for mounting the insurance license plate and a tail light. A stable possibility the liability mark which is indispensable for the fulfillment of the legal mark obligation in Germany is to attach. Also suitable for attachment to the original side bar of Segway PT Inc.
The license plate shows, as required by law, after being mounted in the opposite direction to the rear. In addition, a taillight can be attached. Through the various holes almost all standard bicycle rear lights can be grown.
The license plate holder is fixed by a stable pipe clamp directly at the desired angle to the i2 extension side bracket. Then only the plate plate must be screwed to the holding tube. In order to fix the insurance plate, which is necessary for street legalization of the Segway PT, only 2 screws are necessary and the "moped" plate is flat.
Due to the special design of the plate mounting plate in the upper section, it is ensured that the lamp can shine through upwards. In addition, the rear light is protected from damage by the bent forward bow.
Suitable for the following component:
- Number plate holder for PT Pro Segway i2 cargo frame
Required tool:
- Allen key No. 5 for clamp
- Allen key No. 3 for license plate
Package Contents:
- 1 license plate holder (black) with attachments and screws (without backlight)
Please pay attention to our warnings!
Installation by qualified personnel only !!!
| Color: |
black |
| Condition: |
New |
| Suitable for: |
i2 Gen2i2 SE |
| Shipping weight: |
0,52 kg
|
| Item weight: |
0,50 kg
|
| Dimensions
( Length × Width × Height ):
|
24,00 × 12,00 × 11,00 cm |
Important warning! Risk of injury!
General:
- When using our products, it is important to follow the instructions for installation and manual and the warnings associated with them.
- Special care must be taken while handling with electricity.
- When driving on the road, always observe the locally valid laws and regulations!
- Ensure that you wear adequate protective clothing
- If the vehicle is damaged, it may not be driven under any circumstances. Danger of injury!
Mounting:
- Always switch off your electric vehicle and disconnect the power cable before carrying out maintenance work or replacing parts or accessories.
- Remove both batteries / accumulators before starting work.
- PT Pro is generally not liable for damage caused by incorrectly installed attachments, wear and spare parts.
- Always read the latest authorized operating and installation instructions before installation
- In order to avoid damage and malfunctions, installation should only be carried out by qualified personnel! Incorrect mounting can lead to death or serious injury.
- To minimize the risk of injury, please read and follow all instructions and warnings in the user documentation
Driving the vehicle:
- Use of the vehicle can become deadly or result in serious injury due to loss of control, collisions and falls.
- To minimize the risk of injury, read and follow all instructions and warnings in the user documentation.
- PT Pro recommends that you always wear a helmet when driving the vehicle.
- When using the vehicle, the current road traffic regulations in the respective country must be observed
- Always store batteries and accumulators in a dry place and at room temperature (10 - 25 degrees)
- Charge batteries only at adequately fused sockets and with charging cables designed for this purpose
- Protect batteries and their connectors from moisture
- Always switch off your electric vehicle and disconnect the power cable before carrying out maintenance work or replacing parts or accessories.
- Remove both batteries / accumulators before starting work
- Do not clean with steam jet or garden hose or drive through deep puddles! Clean with a damp cloth!
Lamps:
- Please always ensure sufficient battery power for the duration of your ride.
- Never look directly into the light source. This can lead to blindness
Rims:
- Important: Risk of crashing:
- Check rims for damage before every ride!
- Rims with out-of-balance or which show knocks, hairline cracks and deformation must be replaced immediately.
- Hairline cracks are difficult to detect, danger of breaking! Hairline cracks are possible, especially after accidents and after riding fast over high edges (high pavement, thick roots etc.). Here you save at the wrong place!
- Regularly check the screw connection of the rims!
- Never use rims as load securing points (lashing strap!). Lateral tension forces can damage the rim.
Helmets:
- Caution: Not suitable for motorcycling!
- Please read the warnings inside the helmet!
- Only wear the helmet while riding. Danger of strangulation due to getting caught on the chinstrap when climbing or playing.
- The helmet can no longer fulfil its protective function after a fall, so replace it after every fall.
- Materials age due to UV radiation and external influences. To ensure optimum protection, safety helmets should always be replaced after approx. 5 years.
Caution:
Electronic components are generally excluded from return, cancellation and conversion, as these are specific individual productions due to the respective programming of the component or customer-specific optimizations. Complaints can only be accepted if the component was installed by a trained PT Pro technician. In case of self-installation, any form of warranty or guarantee expires. We refer here to § 312g paragraph 2 BGB additionally apply: I. Exclusion already before the beginning of the production of the goods II. Exclusion only in case of considerable economic disadvantages for the entrepreneur.
There are no reviews yet.
