Battery Li ion 6,6Ah rebuilt battery new cellblock used battery housing

Battery Li ion 6,6Ah rebuilt battery new cellblock used battery housing

SKU: 80615
GTIN: 4251445418608
Category: Battery & Charging Accessories
Manufacturers:

Rebuilt battery for Segway PT with at least 115% performance - guaranteed!

The rebuilt batteries are a good alternative to the original Lishen cells since 2018. A little bit more range at a lower price with a minimum of life time describes this rebuilt battery best.

Suitable for:
Segway Gen2/i2/x2 Segway SE/i2/x2

PT Pro tests these batteries before sale. If the performance is not at least 115%, we do not pass this on to our customers!

€ 1.199,00

incl. 19% VAT , plus (Paketdienst)

Choose tax zone / country of delivery

Low stock level
Delivery time: 1 - 3 Workdays (DE - int. shipments may differ)

pcs

Refurbished batteries for the Segway PT are a good and affordable alternative to new Segway PT batteries.

For this rebuilt battery all cells were replaced by new LiFePo4 Li-Ion cells. Additionally the BMS board (Battery Management System) was checked or replaced by a new one if necessary. Afterwards all battery components are checked by our battery test system. The battery - performance - protocol is enclosed. Each PT Pro battery is provided with a serial number.
The battery housing is in a used condition with corresponding traces of use!

On new equipped Rebuilt - Batteries for Segway PT, which are delivered with performance protocol, there is one year PT Pro - warranty from date of purchase.

Low-performance original Segway PT battery (battery) from Saphion Technology for Segway i2 / x2, both Gen2 and SE series, can be equipped with high performance again.

The LiFePo4 Li-Ion cells used by us have a little more power (6.6Ah), resulting in a slightly higher range. Unfortunately these cells are not as durable as the Lishen cells which are built into the original battery.
This will reduce the range from year to year by about 1.5 - 3%. This is slightly more than with the Lishen cells. Depending on use and storage (heat - cold) it may vary. Since 2018 a good alternative to the original Lishen cells.

Slightly more range at a lower price with a minimum of life span describe this rebuild battery best.

PT Pro also tests new batteries before sale. If this is not at least 115%, we do not give them to our customers!

Suitable for:

Segway Gen2/i2/x2
Segway SE/i2/x2

You should know that!

A Segway PT always needs 2 batteries to ride. Here you should also pay attention to a similar power density of the batteries installed on the Segway PT. The weaker of the two batteries limits the range. Therefore, a strong new battery cannot show its performance when combined with a weaker battery on a Segway PT. Therefore, we recommend that you always replace both batteries on the Segway PT or perform a battery diagnostic to determine the performance of the second battery. Even older batteries can still perform well if cared for properly.

However, it does not always have to be a new battery. If you have a defective battery, PT Pro can often save the defective battery by a so-called battery resuscitation or battery repair.

Tips for the care of your battery on the Segway PT:

Charge the new battery for 12 hours before the first ride.
Always store batteries or Segway PT with a built-in battery in a dry place!
Always store batteries or Segway PT with built-in battery at temperatures above 10 degrees Celsius!
Always leave batteries or Segway PT with built-in battery connected to the power supply. The internal battery charger (UIC) will charge the battery optimally (trickle charge). However, disconnect the battery regularly for 5 minutes to reactivate the trickle charge.

Winter operations are no problem. However, make sure to start the Segway PT at a temperature above 10 degrees and leave the Segway PT on while traveling in cooler temperatures. This will help keep the temperature of the Segway PT up due to the waste heat produced by the battery during use. After use (even when transporting the Segway PT in a car or during a stopover), be sure to store it in a dry place and above 10 degrees Celsius. Then your Segway PT will also survive trips below 0 degrees.

Operating range:

The batteries of the Segway PT are very robust and have a high power density. However, it is also important for rechargeable batteries that the power is provided permanently and even after many charges. With one charge, which only needs about 1 kWh, you can get as far as 40 km, so the electricity costs for 100 km are less than 1 € even with the most expensive electricity tariff.

The range is negatively influenced by:

low outside temperatures let the battery "fall asleep
increased friction of the tires due to low tire pressure
high weight of the driver
uneconomical driving style
strong gradients

Security:

Protect batteries and their connectors from moisture
Charge batteries only at adequately fused sockets and with charging cables designed for this purpose.
Only high quality cells are used for Segway PT batteries
The batteries are of high quality and built in such a way that no short circuits and thus fires occur.

Technical data:

92 LiFePo4 Li-Ion cells
charging time: 5 to 8h
Operating temperatures: -10° to 50°C
Temperature during charging 5° to 30°C
Capacity (Ah) : 6,6 Ah, 480 Wh
Dimensions: 35.7 cm × 19 cm × 8.2 cm
Performance promise of the manufacturer: approx. 1000 charging cycles
Guarantees: 12 months warranty
Weight: piece 5,2 kg

Delivery quantity: 1 piece

Suitable for:	i2 Gen2 x2 Gen2 i2 SE x2 SE all Segway PT Electric wheelchair AddSeat Bi-Go Genny Freee Omeo Apache My Frankie Mobility Cube
Condition:	Rebuilt
Shipping weight:	6,74 kg
Item weight:	5,90 kg
Dimensions ( Length × Width × Height ):	37,00 × 21,00 × 8,00 cm

Important warning! Risk of injury!

General:

When using our products, it is important to follow the instructions for installation and manual and the warnings associated with them.
Special care must be taken while handling with electricity.
When driving on the road, always observe the locally valid laws and regulations!
Ensure that you wear adequate protective clothing
If the vehicle is damaged, it may not be driven under any circumstances. Danger of injury!

Mounting:

Always switch off your electric vehicle and disconnect the power cable before carrying out maintenance work or replacing parts or accessories.
Remove both batteries / accumulators before starting work.
PT Pro is generally not liable for damage caused by incorrectly installed attachments, wear and spare parts.
Always read the latest authorized operating and installation instructions before installation
In order to avoid damage and malfunctions, installation should only be carried out by qualified personnel! Incorrect mounting can lead to death or serious injury.
To minimize the risk of injury, please read and follow all instructions and warnings in the user documentation

Driving the vehicle:

Use of the vehicle can become deadly or result in serious injury due to loss of control, collisions and falls.
To minimize the risk of injury, read and follow all instructions and warnings in the user documentation.
PT Pro recommends that you always wear a helmet when driving the vehicle.
When using the vehicle, the current road traffic regulations in the respective country must be observed
Always store batteries and accumulators in a dry place and at room temperature (10 - 25 degrees)
Charge batteries only at adequately fused sockets and with charging cables designed for this purpose
Protect batteries and their connectors from moisture
Always switch off your electric vehicle and disconnect the power cable before carrying out maintenance work or replacing parts or accessories.
Remove both batteries / accumulators before starting work
Do not clean with steam jet or garden hose or drive through deep puddles! Clean with a damp cloth!

Lamps:

Please always ensure sufficient battery power for the duration of your ride.
Never look directly into the light source. This can lead to blindness

Rims:

Important: Risk of crashing:
Check rims for damage before every ride!
Rims with out-of-balance or which show knocks, hairline cracks and deformation must be replaced immediately.
Hairline cracks are difficult to detect, danger of breaking! Hairline cracks are possible, especially after accidents and after riding fast over high edges (high pavement, thick roots etc.). Here you save at the wrong place!
Regularly check the screw connection of the rims!
Never use rims as load securing points (lashing strap!). Lateral tension forces can damage the rim.

Helmets:

Caution: Not suitable for motorcycling!
Please read the warnings inside the helmet!
Only wear the helmet while riding. Danger of strangulation due to getting caught on the chinstrap when climbing or playing.
The helmet can no longer fulfil its protective function after a fall, so replace it after every fall.
Materials age due to UV radiation and external influences. To ensure optimum protection, safety helmets should always be replaced after approx. 5 years.

Caution:
Electronic components are generally excluded from return, cancellation and conversion, as these are specific individual productions due to the respective programming of the component or customer-specific optimizations. Complaints can only be accepted if the component was installed by a trained PT Pro technician. In case of self-installation, any form of warranty or guarantee expires. We refer here to § 312g paragraph 2 BGB additionally apply: I. Exclusion already before the beginning of the production of the goods II. Exclusion only in case of considerable economic disadvantages for the entrepreneur.